Omron CJ1W-EIP21 Operation Manuals page 141

• *_TargetPLCMdSta (Target Node PLC Operating Flags)
• *_TargetPLCErrSta (Target Node PLC Error Flags)
Sending the Target Node PLC Operating Flags of the Target Node with an IP Address of
192.168.250.2.
IP address = 192.168.250.2
Value of last byte = 2
Target ID = #002
NJ-series Controller
Controller Status
Variable a
Variable b
Variable c
Additional Information
The target ID may be duplicated depending on the IP addresses of the target nodes. In this case,
it is necessary to change the target ID with the Network Configurator so that the same address is
not used twice. For information on how to change the target node ID, refer to step 4 under 7-2-5
Connection Settings.
CJ-series EtherNet/IP Units Operation Manual for NJ-series CPU Unit (W495)
*_TargetPLCMdSta (Target Node PLC Operating Flags)
Controller status (when included)
Output tag set
Input tag set
Connection
EtherNet/IP
7 Tag Data Link Functions
0
1
2
254
255
NJ-series Controller
Controller status (when included)
Controller status
Variable f
Variable g
Variable h
Target data link status
7
7-11