Procedure To Use The Snmp Agent; Procedures; Settings Required For The Snmp Agent - Omron CJ1W-EIP21 Operation Manuals

11-2 Procedure to Use the SNMP Agent

11-2-1 Procedures

1
Make the basic settings.
Refer to 1-5 EtherNet/IP Communications Procedures for the flow of basic operations.
2
Make the following settings in the Special Unit Setup in the Controller Configurations and Setup
of the Sysmac Studio and then set the following on the SNMP Settings Display or SNMP Trap
Settings Display.
• SNMP Service
• Recognition 1
• Recognition 2
3
Select Transfer to Controller from the Controller Menu and click the Yes Button. The Ether-
Net/IP Unit settings are transferred to the CPU Unit.

11-2-2 Settings Required for the SNMP Agent

The following EtherNet/IP Unit settings are made from the Sysmac Studio to use the SNMP agent.
Tab page
SNMP Settings
SNMP Trap Set-
tings
CJ-series EtherNet/IP Units Operation Manual for NJ-series CPU Unit (W495)
Setting
SNMP service
Port No.
Address, location
Send a recognition trap
Recognition 1 and Recognition
2
IP address
Host name
Community name
SNMP trap
Port No.
Trap 1 and trap 2
IP address
Host name
Community name
Version
Setting conditions
Required.
Specified by user.
Note Required to change from the default
value of 161.
Specified by user.
Specified by user.
Select this check box to send a recognition
trap if there is access from an SNMP man-
ager that is not specified (Access other than
Recognition 1 and 2).
Specified by user.
Make these settings to permit access by only
certain SNMP managers.
Required.
Specified by user.
Note Required to change from the default
value of 162.
Required.
Set an IP address or a host name as the
SNMP trap destination.
Specified by user.
Required.
Set the version of the SNMP manager.
11 SNMP Agent
Reference
page 5-9
page 5-10
page 5-11
page 5-12
11-19
11