Omron CJ1W-EIP21 Operation Manuals page 339

Connection status
General Additional
Status
(hex)
01 0107
01 0108
01 0109
01 0110
01 0111
01 0113
01 0114
CJ-series EtherNet/IP Units Operation Manual for NJ-series CPU Unit (W495)
Source of error
Status
(hex)
Error code returned from tar-
get:
Attempted to close a connec-
tion, but that connection was
already closed.
Error code returned from tar-
get:
Attempted to open a connec-
tion with an unsupported con-
nection type.
Error code returned from tar-
get:
The connection size settings
are different in the originator
and target.
Error code returned from tar-
get:
The target was unable to
open the connection, because
of its operating status, such
as downloading settings.
Error code returned from tar-
get:
The RPI was set to a value
that exceeds the specifica-
tions.
Error code generated by origi-
nator or returned from target:
Attempted to open more con-
nections than allowed by the
specifications (CJ2M-EIP21:
32, other CPU Units: 256).
Error code returned from tar-
get:
The Vendor ID and Product
Code did not match when
opening connection.
13 Troubleshooting
Handling
Configuration Configuration
1 2
This error does This error does
not occur. not occur.
This error does Check which
not occur. connection
types can be
used by the tar-
get. (Contact
the manufac-
turer.)
Only multicast
and point-to-
point can be
set.
Check the connection sizes set in the originator and
target.
Check whether Depends on
the tag data link the target's
is stopped at specifications.
the target. (Contact the
(Restart the tag target device's
data link com- manufacturer.)
munications
with the soft-
ware switch.)
This error does Check the tar-
not occur. get's RPI set-
ting
specifications.
Check the con- Check the con-
nection set- nection set-
tings (number tings (number
of connec- of connec-
tions) at the tions) at the
originator and originator and
target. target.
Check the con-
nection specifi-
cations for
another com-
pany's devices.
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
Confirm that
the target
device's EDS
file is correct.
Configuration
2
This is not an
error because
the connection
is already
closed.
Check which
connection
types can be
used by the
originator.
(An error will
occur if a con-
nection other
than multicast
or point-to-point
is set.)
13
Check whether
the tag data link
is stopped at
the originator.
(Restart the tag
data link com-
munications
with the soft-
ware switch.)
Set the origina-
tor's RPI setting
to 10 seconds
or less.
Check the con-
nection set-
tings (number
of connec-
tions) at the
originator and
target.
Check the con-
nection specifi-
cations for
another com-
pany's devices.
Check the origi-
nator's connec-
tion settings.
13-21