Mitsubishi MELSEC-L series Programming Manual page 221

Device Item
Error-detected station No.
[17]
s1
*3
*1 :
*2 :
*3 :
Setting data
Number of the station where an error was detected is stored.
(However, when an error was detected at the host station, the network
number is not stored.)
Ethernet
1 to 64
MELSECNET/H
CC-Link IE controller
1 to 120
network
Specification is possible when the host station is a network module or Ethernet module of function
version D or later.
(Specification is not possible for other modules. An access is always made to the target station CPU.)
Specification is possible when the versions of the QCPU and the network module on the host station and
the target station are as indicated below.
(Specification is not possible for other modules. An access is always made to the target station CPU.)
• Network module: The first five digits of the serial number are '06092' or higher.
• QCPU: The first five digits of the serial number are '06092' or higher.
This becomes valid only when 1 is set in bit 7 of Error completion type (
5.4 CC-Link IE Controller Network, MELSECNET/H, and Ethernet Instruction
J_REQ, G_REQ
Setting range
Setting side
System
–
[0]).
s1
5.4.8 REQ instruction
*1
5
5-175