Mitsubishi MELSEC-L series Programming Manual page 145

[ST]
PLS(X50, Var_Flag_Inst);
IF(Var_Flag_Inst=TRUE)THEN
MOV(TRUE, 1, Var_ControlData[0]);
MOV(TRUE, H3E8, Var_ControlData[2]);
MOV(TRUE, 10, Var_ControlData[3]);
MOV(TRUE, H3946, Var_Frame[0]);
MOV(TRUE, H3030, Var_Frame[1]);
MOV(TRUE, H3030, Var_Frame[2]);
MOV(TRUE, H4646, Var_Frame[3]);
MOV(TRUE, H3030, Var_Frame[4]);
TO(TRUE, H8, H2000, 1, 1);
G_PUTE(TRUE, H08, Var_ControlData,Var_Frame[0], Var_Result);
END_IF;
IF(Var_Result[0]=TRUE)THEN
IF(Var_Result[1]=FALSE)THEN
SET(TRUE, Var_Flag_Normal);
ELSE
SET(TRUE, Var_Flag_Error);
END_IF;
END_IF;
5.2 Serial Communication and Modem Interface Instruction
(* Registration request pulse *)
(* Sets registration request *)
(* Sets user frame number *)
(* Sets number of registered bytes *)
(* User frame 0 *)
(* User frame 1 *)
(* User frame 2 *)
(* User frame 3 *)
(* User frame 4 *)
(* Sets write enable in flash ROM side *)
(* Registers user frame *)
(* Execution finished *)
(* Normal completion *)
(* Turns normal completion flag ON *)
(* Error completion *)
(* Turns error completion flag ON *)
5.2.12 PUTE instruction
G_PUTE
5
5-99