Top Panel; Removing The Top Panel - Compaq AlphaServer 1000A Owner's Manual

Top Panel

You must remove the top panel before you install or remove any internal component.

Removing the Top Panel

To remove the top panel (reference Figure 5-1):
_________________________ Caution ___________________________
Make sure the system unit On/Off switch is in the "off" position before you
remove the system top and side panels.
____________________________________________________________
1. Shut down the operating system following the instructions in the operating system
documentation.
2. Set the On/Off switches on all external options connected to the system to the off
position.
3. Set the On/Off switch on the system unit to the off position. An interlocking sensor
switch inside the system unit automatically turns off the system if you remove the top
panel and do not turn off the system.
_________________________Warning ___________________________
Wait at least 15 seconds to allow time for the power supply capacitors to
discharge safely.
____________________________________________________________
4. Turn the lock to the left to unlock the system unit.
5. Grasp the finger groove at the rear of the top panel and pull the top panel straight back
(about four inches). Lift up on the panel.
Installing and Removing Components
AlphaServer 1000A Rackmount Owner's Guide 5-3