Making Measurements
Measuring Transmission Response
4. The analyzer will measure each standard and then calculate the new
5. The calibration may be saved in memory or on a disk for later use if you
N O T E
Changing sweep frequencies (and other source parameters] may affect your calibration. See Chapter 6,
"Calibrating for Increased Measurement Accuracy," for more information.
3-20
深圳市盛腾仪器仪表有限公司
calibration coefficients. The message "Calibration complete . x will
appear for a few seconds when the analyzer is done calculating the new
error correction array.
wish. However, the current calibration for each measurement channel is
always saved in nonvolatile (battery-backed) memory and will be used
the next time the analyzer is preset (see note below) or turned on. See
Chapter 6 for information on saving calibrations to the analyzer's internal
memory, the analyzer's random access memory (RAM), or to a floppy disk.
Tel:0755-83589391
Fax:0755-83539691
Website: www.Sengt.co