Using Instrument Functions Using Markers - HP 8711C User Manual

Using Instrument Functions
Using Markers
If a marker is on, two lines of numbers follow the marker annotation: the
upper line indicates the frequency in MHz, and the lower line indicates the
magnitude.
The examples in this section are shown with a transmission response
measurement of a filter. To follow along with these examples; use the filter
that was shipped with your analyzer, connect the equipment as shown, and
set up the analyzer by pressing the keys shown below the equipment setup.
N O T E
When you make a hardcopy of your measurement results that contain displayed markers, you can
choose to have a marker table appear on the hardcopy Refer to "Printing and Plotting Measurement
Results" later in this chapter.
4 - 4
深圳市盛腾仪器仪表有限公司
N E T W O R K A N A L Y Z E R
Figure 4-2. Connect the Filter to the Analyzer
Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.c