HP 8711C User Manual page 466

limit Test Output
Video Output Color VGA
HP-IB
Parallel Port
L A N
DIN Keyboard
line Power
User TTL Input/Output
深圳市盛腾仪器仪表有限公司
This connector outputs a TTL signal of the limit test results. Pass: TTL high;
Fail: TTL low.
This connector provides signals to drive an external VGA compatible monitor.
See 'Ihble 8-2 for more information.
Vertical rate: 59.82 Hz
Horizontal rate: 31.41 kHz (31.84 ps)
Pixel rate: 25 MHz
This connector allows communication with compatible devices including
external controllers, printers, plotters, disk drives, and power meters.
This 25-pin female connector is used with parallel (or Centronics interface)
peripherals such as printers and plotters. It can also be used as a general
purpose I/O port, with control provided by IHASIC and SCPI commands.
This g-pin male connector is used with serial peripherals such as printers and
plotters.
This RJ-45, "ether-twist," connector is used for connecting the analyzer to a
LAN. This connector is functional only with Option lF7. See the Option lF7
User's Guide supplement for more information on using this connector.
This connector is used for connecting and using an IBM PC-AT compatible
keyboard for title entry, remote front-panel operation, and for BASIC
programming (Option lC2).
47 to 66 Hz
115 V nominal (90 V to 132 V) or 230 V nominal (198 V to 254 V).
300 VA max
This connector provides a bidirectional open collector TTL signal that can be
accessed by IBASIC and SCPI commands. It also can be used as a sweep out
connector, and as a softkey-auto step connector (with an external switch).
Tel:0755-83589391
Specifications and Characteristics
General Characteristics
Fax:0755-83539691
10-15
Website: www.Sengt.c