Depending on your selection, the analyzer is set to one of the following
configurations. (The SRL and Fault Location configurations are discussed in
the
Frequency Range2
0.300 MHz-1300 MHz 0.300 MHz-1300
Frequency Range3
0.300
Power Level
preset power level4
Measurement Channel 1
Measurement Channel 2
Format
Number of Points
Sweep Time Mode
Sweep Triggering
Detection
Mode
Measurement Paths
Averaging
System Bandwidth
1 Options IDA and 106 only
2
HP 8711C
3
HP 8713C
4 Preset power level is user-defined by using the
5 Maximum power is dependent upon the option configuration of your analyzer. See Chapter 10 to determine the maximum specified power for your analyzer.
3-16
深圳市盛腾仪器仪表有限公司
the BEGIN Key to Make Measurements
Option 100 User's Guide Supplement.)
Table 3-l. Measurement Configurations from the [BEGIN) Key
Transmission
Reflection
preset power level4
Transmission
Reflection
off
Off
201
201
Auto
Auto
Continuous
Continuous
Narrowbend
Narrowband
Off
Off
Medium Wide
Medium
Preset Pwr
Tel:0755-83589391
Power
M H z 10 MHz-1300 M H z 1 0 MHz-1300 M H z IO MHz-1300 M H z
preset power level4 preset power level4 maximum specified5