HP 8711C User Manual page 167

Select the Disk
Define and Save Data
深圳市盛腾仪器仪表有限公司
1. If you are using a floppy disk, place a DOS formatted disk in the disk drive
you are using. If your disk is not formatted, refer to the procedure in
"Formatting a Floppy Disk" located later in this section.
Press Select Disk and press the key that corresponds to
( )
SAVE RECALL
the disk where you are going to save data:
Press Nan-Val ftAM Disk to save to the analyzer's internal
l
non-volatile memory. (Nonvolatile means that the information will be
retained in memory when the power to the analyzer is turned off.) This
is the default selection.
Press Volatile RAR Disk if you are saving to the analyzer's internal
l
volatile memory. (Volatile means that the information will be lost if
power to the analyzer is turned off.)
o If you have the IBASIC Option lC2 installed in your analyzer
you can configure the volatile RAM disk by pressing the
instruments without BASIC.)
o When this key is pressed, a message appears, displaying the current
percentage allocation between RAM disk and BASIC memory.
o To change the memory allocation, press %&ffy Sizlp , then enter
the new RAM disk allocation.
o The power must be cycled on the analyzer for the changes in
memory allocation to take effect.
Press Internal 3.5" Disk if you are saving to the 3.5 inch disk in
l
the analyzer's built-in disk drive (Only MS-DOS format disks can be
used.)
1. Press Priar l&xm Define Save .
Press In& State OFF if you do
l
(This will save measurement data only.)
Press Cal ON if you want to save the active measurement calibration.
l
Press Data ON if you want to save the measurement data that is
l
displayed on the network analyzer screen.
Tel:0755-83589391
Using Instrument Functions
Saving and Recalling Measurement Results
not
want the instrument state saved.
Fax:0755-83539691
4-65
Website: www.Sengt.c