HP 8711C User Manual page 436

Match
FULL apPft
C A U T I O N
深圳市盛腾仪器仪表有限公司
uncertainties that can be viewed after performing a cal check.
Refer to Chapter 6 for more information on using cal check.
Access Keys: ICAL) Czil Check Bisw Gal check
the frequency span of source. When selected, it changes the frequency
annotation from start/stop to center/span.
See "Entering Measurement Parameters" in Chapter 2 for more information.
(measurement channel 1 on top, measurement channel 2 on the bottom) and
full (both measurement channels on full screen).
See "Entering Measurement Parameters" in Chapter 2 for more information.
Access Keys: [W) More IIisplagr
switches between the default and an alternate conEguration during a sweep
to avoid spurs.
Sweeptime usually increases when this option is selected.
See "Reducing Trace Noise" in Chapter 5 for more information.
The measurement calibration must be performed with the same spur avoid
option used in the measurement or your results may be invalid.
Tel:0755-83589391 Fax:0755-83539691
Reference
s
9-73
Website: www.Sengt.co