3
Set the control method.
Press the O
(Level) Key for at
least 3 seconds.
Standard Models
PID Control
M ( Press the M (Mode)
Key several times to display
(Press and hold the M Key to
cycle through the parameters
ON/OFF Control
E5@D Digital Temperature Controllers User's Manual (H224)
Operation Level
Operation Level
The display flashes.
Initial Setting Level
cntl (CNTL).
in reverse.)
Initial Setting Level
3 Part Names and Basic Procedures
Initial Setting Level
Initial Setting Level
in-t (IN-T) will be displayed
to show that the Initial Setting
Level has been entered.
cntl (CNTL): Indicates the control method.
If onof (ON/OFF control) is displayed, press
the U (Up) Key to change to pid (PID) (PID
control).
cntl (CNTL): Indicates the control method.
The default setting is onof (ONOF: ON/OFF control).
If pid (PID control) is displayed, press
the D (Down) Key to change to onof
(ONOF) (ON/OFF control).
3
3 - 13