Omron E5*D series User Manual page 169

 Control Output ON/OFF Count Monitors
With Control Output 1 and 2 ON/OFF outputs (relay outputs or voltage outputs for driving SSR), the
number of times that a control output turns ON and OFF can be counted.
You can display the counts or monitor them through communications.
The monitor range is 0 to 999,900 times. The counts are not recorded beyond that.
There is no function to link this data with an alarm output.
There is a function to reset the control output ON/OFF counts. (Resetting is possible only with a key
operation.)
Setting/monitor data
Control Output 1
ON/OFF Count Monitor
Control Output 2
ON/OFF Count Monitor
ON/OFF Counter Reset
Operating Procedure
• Checking the Power ON Time Monitor
1
Press the M Key several times in the Advanced Function Set-
ting Level to display pwtm (Power ON Time Monitor).
2
Check the power ON time.
Every 10 hours is one count.
Therefore, in the example on the right, the power ON time is
between 10 hours and 19 hours 59 minutes.
• Checking the Ambient Temperature Monitor
1
Press the M Key several times in the Advanced Function Set-
ting Level to display abtm (Ambient Temperature Monitor).
2
Check the ambient temperature.
In the example on the right, the temperature would be 28°C if the
temperature unit was °C.
E5@D Digital Temperature Controllers User's Manual (H224)
Display Monitor range
0 to 9999
ra1m
0 to 9999
ra2m
0: Resetting is
rac
disabled.
1: Control Output 1
ON/OFF Count
Monitor parameter is
reset.
2: Control Output 2
ON/OFF Count
Monitor parameter is
reset.
5 Advanced Operations
Unit Default
100 times 0
100 times 0
--- 0
Advanced Function Setting
Level
pwtm
0000
pwtm
0001
Advanced Function Setting
Level
abtm
0028
abtm
0028
Level
Advanced
Function
Setting
Level
Advanced
Function
Setting
Level
Advanced
Function
Setting
Level
5
Power ON
Time
Ambient
Temperature
5 - 23