Omron E5*D series User Manual page 48

2 Preparations
3
Insert the new interior body into the rear case.
( 1 ) When inserting the interior body back into the
rear case, mount the sealing rubber in the
position shown on the right, make sure the PCBs
are parallel to each other, and press the interior
body toward the rear case and into position,
making sure that the sealing rubber does not
move.
( 2 ) When you press the Digital Controller into
position, press down on the rear case hooks so that the case
hooks securely lock in place. (There are rear case hooks at
both the top and bottom of the rear case.) If the Digital
Controller is not correctly mounted into the rear case, the rear
case may not be waterproof. When inserting the Digital
Controller, do not allow the electronic components to touch the
rear case. (The E5CD is shown in the figure.)
Additional Information
Removing the draw-out jig when only one hook is caught in the
draw-out jig insertion hole
(1) Pull the Draw-out Jig slowly in the direction shown in the figure.
(This step is the same even if the other hook is caught.)
(2) Confirm that the Draw-out Jig is free of the Draw-out Jig
insertion hole.
(3) If the interior body separates from the rear case, slowly press
the interior body into the rear case in a horizontal direction.
(The E5CD is shown in the figure.) If you do not follow the
procedures above, the Digital Controller may be damaged.
2 - 8
Top View
Sealing rubber position
(1)
PCBs
Case hooks Keep the PCBs parallel
to each other and inset
them into the rear case.
(2)
(2)
(1)
E5@D Digital Temperature Controllers User's Manual (H224)
Rear case hooks
Rear case hooks
(2)
(3)