Omron E5*D series User Manual page 243

a-m
• This parameter switches the Digital Controller between Automatic and Manual Modes.
• If the O Key is pressed for at least 3 seconds when the Auto/Manual Switch parameter is
displayed, the Manual Mode will be entered and the manual control level will be
Operation
displayed.
• This parameter will not be displayed if an event input is set to "MANU" (auto/manual).
• The default parameter mask settings mask (hide) this parameter.
 Related Parameters
See
See
PID ON/OFF (Initial Setting Level): Page 6-43
Parameter Mask Setting (Advanced Function Setting Level): Page 6-95
Parameter Mask Enable (Protect Level): 6-4
m-sp
To use the multi-SP function, preset up to eight set points (SP 0 to 7) in the Adjustment
Level, and then switch the set point either by operating the keys or by using external input
signals (event inputs).
Function
This parameter is used to select set points 0 to 7.
sp-m
This parameter monitors the set point during SP ramp operation.
A ramp is used to restrict the change width of the set point as a rate of change.
This parameter is displayed when a set value is input for the SP Ramp Set Value parameter
(Adjustment Level).
Function
When not in ramp operation, the set point will be the same as the one displayed for the Pro-
cess Value/Set Point parameter.
SP: SP lower limit to SP upper limit
Monitor
E5@D Digital Temperature Controllers User's Manual (H224)
Auto/Manual Switch
Multi-SP Set Point Selection
(Set Points 0 to 7)
Set Point During SP Ramp
Monitor range
The Event Input Assignment 1 to 4 parameters
must not be set to Auto/Manual.
The control must be set to 2-PID control.
The Number of Multi-SP Points parameter must not
be set to OFF and the Event Input Assignment 1 to
Event Input Assignment 4 parameters must not be
set to "Multi-SP No. switching bit 0" to "Multi-SP
No. switching bit 2."
The SP Ramp Set Value parameter must not be set
to OFF and the SP Ramp Fall Value parameter must
not be set to SAME or OFF.
6 Parameters
MASK
6
Unit
EU
6 - 9