Omron E5*D series User Manual page 315

sub1
sub2
sub3
sub4
• These parameters set the function to assign to auxiliary outputs 1 to 4.
*1 If c-o is assigned for standard control, a value equivalent to 0% will be output.
*2 · When heating/cooling control is selected for the E5CD or E5CD-B, auxiliary output 2 is
· If heating/cooling control is selected for the E5ED or E5ED-B when there is only one control
*3 Can be selected when the Program Pattern parameter is set to OFF, but the function will be
disabled.
*4 WR1 to WR8 are not displayed when the logic operation function is not used.
*5 If the Digital Controller is equipped with HB/HS alarm detection, it is set by default to ha (Heater
Alarm).
E5@D Digital Temperature Controllers User's Manual (H224)
Auxiliary Output 1 Assignment
Auxiliary Output 2 Assignment
Auxiliary Output 3 Assignment
Auxiliary Output 4 Assignment
Setting range
Disabled
none:
Control output (heating)
o:
c-o:
Control output (cooling)
Alarm 1
alm1:
Alarm 2
alm2:
Alarm 3
alm3:
Alarm 4
alm4:
Heater alarm
ha:
HB alarm
hb:
HS alarm
hs:
Input error
s.err:
Disabled
none:
p.end:
Program end output
RUN output
run:
Integrated Alarm
alm:
*4
wr1:
Work bit 1
*4
wr2:
Work bit 2
*4
wr3:
Work bit 3
*4
wr4:
Work bit 4
*4
wr5:
Work bit 5
*4
wr6:
Work bit 6
*4
wr7:
Work bit 7
*4
wr8:
Work bit 8
assigned as the control output for cooling.
output, the auxiliary output 4 terminal is assigned as the control output for cooling. (However,
if the Digital Controller has two auxiliary outputs, auxiliary output 2 is the cooling control
output.)
There must be an auxiliary output 1.
There must be an auxiliary output 2.
There must be an auxiliary output 3.
There must be an auxiliary output 4.
Auxiliary Output 1 Assignment: alm1
Auxiliary Output 2 Assignment: alm2
*1
Auxiliary Output 3 Assignment: alm3
Auxiliary Output 4 Assignment: alm4
*3
6 Parameters
Default
*5
*2
*2
6 - 81
6