Omron E5*D series User Manual page 329

ra1m
ra2m
• These parameters monitor the number of times that control outputs 1 and 2 are turned
ON and OFF.
Function
• These parameters are not initialized for the Parameter Initialization parameter. To
initialize them, reset (initialize) them with the ON/OFF Counter Reset parameter.
Setting
 Related Parameters
ON/OFF Counter Reset (Advanced Function Setting Level): Page 6-95
See
See
rac
This parameter resets the ON/OFF counter for specified control outputs.
Function
0:
Setting
1:
2:
 Related Parameters
Control Output 1 ON/OFF Count Monitor (Advanced Function Setting Level): Page 6-95
See
See
Control Output 2 ON/OFF Count Monitor (Advanced Function Setting Level): Page 6-95
pmst
• You can use a key operation to hide parameters that do not need to be displayed.
• This allows you to prevent incorrect operations for parameters or to change the
Function
parameter display configuration according to the application.
If you set the Parameter Mask Setting parameter to ON, Parameter Mask Mode is entered.
Refer to 5-12-1 Parameter Mask Setting for information on masking parameters after you
enter Parameter Mask Mode.
Operation
 Related Parameters
Parameter Mask Enable (Protect Level): Page 6-6
See
See
E5@D Digital Temperature Controllers User's Manual (H224)
Control Output 1 ON/OFF Count
Monitor
Control Output 2 ON/OFF Count
Monitor
Monitor range
0 to 9999
ON/OFF Counter Reset
Setting range
Resetting is disabled.
Control Output 1 ON/OFF Count Monitor parameter is reset.
Control Output 2 ON/OFF Count Monitor parameter is reset.
Parameter Mask Setting
Control outputs 1 and 2 must be supported. Relay
or voltage outputs (for driving SSR) must be used.
Unit Default
100 times 0
Control outputs 1 and 2 must be supported. Relay
or voltage outputs (for driving SSR) must be used.
6 Parameters
Default
0
6 - 95
6