Exhaust Gas Temperature Sensor 1, 2 And 3 Inspection; Diesel Particulate Filter Differential Pressure Sensor Removal And Installation; Specifications; Tightening Torque Specifications - Suzuki GRAND VITARA 2005 Service Manual

Exhaust Gas Temperature Sensor 1, 2 and 3
Inspection
1) Disconnect negative (–) cable at battery.
2) Disconnect exhaust gas temperature sensor 1, 2
and/or 3 connectors.
3) Measure resistance between terminals of exhaust
gas temperature sensor 1, 2 and/or 3 connectors.
If resistance is out of specification, replace exhaust
gas temperature sensor 1, 2 and/or 3.
Exhaust gas temperature sensor resistance
Exhaust gas temperature sensor 1
1.77 kΩ at 400 °C, 752 °F
0.7 kΩ at 500 °C, 932 °F
Exhaust gas temperature sensor 2
106 kΩ at 50 °C, 122 °F
33.5 kΩ at 100 °C, 212 °F
Exhaust gas temperature sensor 3
132 kΩ at 250 °C, 482 °F
3.5 kΩ at 500 °C, 932 °F

Tightening Torque Specifications

Fastening part
Exhaust gas temperature sensor 1
Exhaust gas temperature sensor 2
Exhaust gas temperature sensor 3
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information: in Section 0A".
Diesel Particulate Filter Differential Pressure
Sensor Removal and Installation
S5JB0B1206008
Removal
1) Disconnect negative (–) cable at battery.
2) Detach diesel particulate filter differential pressure
sensor (1) from its bracket.
3) Disconnect diesel particulate filter differential
pressure sensor connector (1) and hoses (2) from
diesel particulate filter differential pressure sensor
(3).
I5JB0B120014-01
Installation
Reverse removal procedure of installation.

Specifications

Tightening torque
N⋅m kgf-m
40
30
30
Aux. Emission Control Devices:
1
3
lb-ft
4.0 29.0
3.0 22.0
3.0 22.0
1B-3
S5JB0B1206009
I5JB0B120015-01
1
2
I5JB0B120016-01
S5JB0B1207001
Note