Cisco Catalyst 4500 Series Configuration Manual page 628

pppoe intermediate-agent (interface)
pppoe intermediate-agent (interface)
This command takes effect only if you enable the pppoe intermediate-agent global command.
Note
To enable the PPPoE Intermediate Agent feature on an interface, use the pppoe intermediate-agent
command. To disable the feature, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default Disabled on all interfaces.
Command Modes Interface configuration mode
Command History Release
12.2(50)SG
Usage Guidelines PPPoE Intermediate Agent is enabled on an interface provided the PPPoE Intermediate Agent is enabled
both on the switch and the interface.
Examples The following example shows how to enable the PPPoE Intermediate Agent on an interface:
Switch(config-if)# pppoe intermediate-agent
The following example shows how to disable the PPPoE Intermediate Agent on an interface:
Switch(config-if)# no pppoe intermediate-agent
Related Commands Command
pppoe intermediate-agent
format-type (interface)
pppoe intermediate-agent
limit rate
pppoe intermediate-agent
trust
pppoe intermediate-agent
vendor-tag strip
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-588
pppoe intermediate-agent
no pppoe intermediate-agent
Modification
This command was introduced on the Catalyst 4500 series switch.
Description
Sets circuit ID or remote ID for an interface.
Limits the rate of the PPPoE Discovery packets coming on an
interface.
Sets the trust configuration of an interface.
Enables vendor-tag stripping on PPPoE Discovery packets from
PPPoE Server (or BRAS).
Chapter 2