Cisco Catalyst 4500 Series Configuration Manual page 464

lldp tlv-select power-management
lldp tlv-select power-management
To to enable power negotiation through LLDP, use the lldp tlv-select power-management interface
command.
Syntax Description This command has no arguments or keywords.
Command Default
Enabled on POEP ports
Command Modes Interface level
Command History Release
12.2(54)SG
Usage Guidelines
You need to disable this feature if you do not want to perform power negotiation through LLDP.
This feature is not supported on non-POEP ports; the CLI is suppressed on such ports and TLV is not
exchanged.
Examples The following example shows how to enable LLDP power negotiation on interface Gigabit Ethernet 3/1:
Switch# config t
Enter configuration commands, one per line.
Switch(config)# int gi 3/1
Switch(config-if)# lldp tlv-select power-management
Related Commands Command
lldp run
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-424
lldp tlv-select power-management
Modification
This command was introduced on the Catalyst 4500 series switch.
End with CNTL/Z.
Description
Cisco IOS Command Reference library.
Chapter 2