Debug Lacp - Cisco Catalyst 4500 Series Configuration Manual

debug lacp

debug lacp
To debug the LACP activity, use the debug lacp command. To disable the debugging output, use the no
form of this command.
Syntax Description
all
event
fsm
misc
packet
Command Default
Debugging of LACP activity is disabled.
Command Modes Privileged EXEC mode
Command History Release
12.1(13)EW
Usage Guidelines
This command is supported only by the supervisor engine and can be entered only from the
Catalyst 4500 series switch console.
Examples The following example shows how to enable the LACP miscellaneous debugging:
Switch# debug lacp
Port Aggregation Protocol Miscellaneous debugging is on
Switch#
Related Commands Command
undebug pagp (same as no debug pagp)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-166
debug lacp [all | event | fsm | misc | packet]
no debug lacp
(Optional) Enables all LACP debugging.
(Optional) Enables the debugging of the LACP events.
(Optional) Enables the debugging of the LACP finite state machine.
(Optional) Enables the miscellaneous LACP debugging.
(Optional) Enables the LACP packet debugging.
Modification
This command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Disables debugging output.
OL-30934-01