Chapter 2
show qos aggregate policer
To display QoS aggregate policer information, use the show qos aggregate policer command.
Syntax Description
aggregate_name
Command Default
This command has no default settings.
Command Modes
Privileged EXEC mode
Command History
Release
12.1(8a)EW
Usage Guidelines
This command is not supported on Supervisor Engine 6-E, Supervisor Engine 6L-E, Catalyst 4900M,
Catalyst 4948E, and Catalyst 4948E-F.
The aggregate policer name is case sensitive.
Examples
The following example shows the output if you do not enter any keywords:
Switch# show qos aggregate policer
Policer aggr-1
Rate(bps):10000000 Normal-Burst(bytes):1000000
conform-action:transmit exceed-action:policed-dscp-transmit
Policymaps using this policer:
Switch#
Related Commands
Command
qos trust
show qos aggregate policer [aggregate_name]
(Optional) Named aggregate policer.
Modification
This command was introduced on the Catalyst 4500 series switch.
ipp5-policy
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Defines a named aggregate policer.
show qos aggregate policer
2-945