Cisco Catalyst 4500 Series Configuration Manual page 599

Chapter 2
Switch(config-pmap)# class class1
Switch(config-pmap-c)# police 100000 20000 exceed-action
Switch(config-pmap-c)# set-dscp-transmit cs3
Switch(config-pmap-c)# set-cos-transmit 3
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class2
Switch(config-pmap-c)# police cir 32000 pir 64000 conform-action transmit exceed-action
Switch(config-pmap-c)# set-dscp-transmit cs3 violate-action drop
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class3
Switch(config-pmap-c)# set dscp cs3
Switch(config-pmap-c)# exit
Switch#
The following example shows how to delete the policy map called policymap2:
Switch# configure terminal
Switch(config)# no policy-map policymap2
Switch#
You can verify your settings by entering the show policy-map privileged EXEC command.
Related Commands Command
class
class-map
policy-map
service-policy (interface
configuration)
show policy-map
Description
Specifies the name of the class whose traffic policy you want to
create or change.
Creates a class map to be used for matching packets to the class
whose name you specify and to enter class-map configuration
mode.
Creates or modifies a policy map that can be attached to multiple
ports to specify a service policy and to enter policy-map
configuration mode.
Attaches a policy map to an interface or applies different QoS
policies on VLANs that an interface belongs to.
Displays information about the policy map.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
policy-map
2-559