Cisco Catalyst 4500 Series Configuration Manual page 1129

Chapter 2
subscribe-to-alert-group diagnostic
To subscribe a destination profile to the Diagnostic alert group, use the subscribe-to-alert-group
diagnostic command.
Syntax Description severity catastrophic
disaster
fatal
critical
major
minor
warning
notification
normal
debugging
Command Default normal
Command Modes cfg-call-home-profile
Command History Release
12.2(52)SG
Usage Guidelines To enter profile call-home configuration submode, use the profile command in call-home configuration
mode.
Examples The following example shows how to configure the "diagnostic" alert-group with "normal" severity:
Switch(config)# call-home
Switch(cfg-call-home)# profile cisco
Switch(cfg-call-home-profile)# subscribe-to-alert-group diagnostic severity normal
subscribe-to-alert-group diagnostic [severity catastrophic | disaster | fatal | critical | major |
minor | warning | notification | normal | debugging]
(Optional) Specifies network wide catastrophic failure (highest severity).
(Optional) Specifies significant network impact.
(Optional) Specifies that the system is unusable (system log level 0).
(Optional) Specifies that immediate attention is needed (system log level 1).
(Optional) Specifies a major condition (System log level 2).
(Optional) Specifies a minor condition (System log level 3).
(Optional) Specifiies a warning condition (System log level 4).
(Optional) Specifies an informational message (System log level 5).
(Optional) Specifies returning to a normal state (System log level 6).
(Optional) Specifies a debugging message (Lowest severity).
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
subscribe-to-alert-group diagnostic
2-1079