Chapter 2
logging event link-status global (global configuration)
To change the default switch-wide global link-status event messaging settings, use the
logging event link-status global command. Use the no form of this command to disable the link-status
event messaging.
Syntax Description
This command has no arguments or keywords.
Command Default
The global link-status messaging is disabled.
Command Modes
Global configuration mode
Command History
Release
12.2(25)SG
Usage Guidelines
If link-status logging event is not configured at the interface level, this global link-status setting takes
effect for each interface.
Examples
The following example shows how to globally enable link status message on each interface:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# logging event link-status global
Switch(config)# end
Switch#
Related Commands
Command
logging event link-status (interface
configuration)
logging event link-status global
no logging event link-status global
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
logging event link-status global (global configuration)
End with CNTL/Z.
Description
Enables the link-status event messaging on an interface.
2-425