Cisco Catalyst 4500 Series Configuration Manual page 558

name
name
To set the MST region name, use the name command. To return to the default name, use the no form of
this command.
Syntax Description
name
Command Default
The MST region name is not set.
Command Modes MST configuration mode
Command History Release
12.1(12c)EW
Usage Guidelines Two or more Catalyst 4500 series switches with the same VLAN mapping and configuration version
number are considered to be in different MST regions if the region names are different.
Examples The following example shows how to name a region:
Switch(config-mst)# name Cisco
Switch(config-mst)#
Related Commands Command
instance
revision
show spanning-tree mst
spanning-tree mst
configuration
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-518
name name
no name name
Specifies the name of the MST region. The name can be any string with a maximum
length of 32 characters.
Modification
This command was introduced on the Catalyst 4500 series switch.
Description
Maps a VLAN or a set of VLANs to an MST instance.
Sets the MST configuration revision number.
Displays MST protocol information.
Enters the MST configuration submode.
Chapter 2