Cisco Catalyst 4500 Series Configuration Manual page 206

debug nmsp
debug nmsp
To the enable debugging of the Network Mobility Services Protocol (NMSP) on the switch, use the
debug nmsp command. This command is available only when your switch is running the cryptographic
(encrypted) software image. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Command Default
Debugging is disabled.
Command Modes Privileged EXEC mode
Command History Release
12.2(52)SG
Usage Guidelines
The undebug nmsp command is the same as the no debug nmsp command.
Related Commands Command
show debugging
show nmsp
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-168
debug nmsp {all | connection | error | event | packet | rx | tx}
no debug nmsp
Modification
This command was introduced on the Catalyst 4500 series switch.
Description
Displays information about the types of debugging that are enabled.
Displays the NMSP information.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-30934-01