Cisco Catalyst 4500 Series Configuration Manual page 973

Chapter 2
show policy-map interface vlan
To show the QoS policy-map information applied to a specific VLAN on an interface, use the
show policy-map interface vlan command.
Syntax Description interface interface-id
vlan vlan-id
Command Modes Privileged EXEC mode
Command History Release
12.1(13)EW
Examples
The following example show a configuration on a non-Supervisor Engine 6-E:
interface GigabitEthernet3/1
vlan-range 20,400
service-policy input p1
vlan-range 300-301
service-policy output p2
The following example shows how to display policy-map statistics on VLAN 20 on the Gigabit Ethernet
6/1 interface:
Switch# show policy-map interface gigabitEthernet 3/1 vlan 20
GigabitEthernet3/1 vlan 20
Service-policy input: p1
Switch#
The following example shows a configuration on a non-Supervisor Engine 6-E:
interface fastethernet6/1
vlan-range 100
service-policy in p1
The following example shows how to display policy-map statistics on VLAN 100 on the FastEthernet
interface:
Switch# show policy-map interface fastEthernet 6/1 vlan 100
FastEthernet6/1 vlan 100
Service-policy input: p1
show policy-map interface vlan interface-id vlan vlan-id
(Optional) Displays QoS policy-map information for a specific interface.
(Optional) Displays QoS policy-map information for a specific VLAN.
Modification
This command was introduced on the Catalyst 4500 series switch.
Class-map: class-default (match-any)
0 packets
Match: any
0 packets
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
show policy-map interface vlan
2-925