Cisco Catalyst 4500 Series Configuration Manual page 259
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
dot1x credentials (global configuration)
Use the dot1x credentials global configuration command to configure a profile on a supplicant switch.
Syntax Description
profile
Command Default
No profile is configured for the switch.
Command Modes
Global configuration
Command History
Release
12.2(54)SG
Usage Guidelines
You must have another switch set up as the authenticator for this switch to be the supplicant.
Examples
The following example shows how to configure a switch as a supplicant:
Switch(config)# dot1x credentials profile
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands
Command
cisp enable
show cisp
dot1x credentials profile
no dot1x credentials profile
Specify a profile for the supplicant switch.
Modification
This command was introduced.
Description
Enables Client Information Signalling Protocol (CISP).
Displays CISP information for a specified interface.
Refer to IOS documentation.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
dot1x credentials (global configuration)
2-221
Advertisement
Table of Contents
