Cisco Catalyst 4500 Series Configuration Manual page 301

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
exporter (netflow-lite monitor submode)
NetFlow-lite is supported only on Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
Note
To assign an exporter in netflow-lite monitor submode, use the exporter command. To delete a sampler,
use the no form of this command.
Syntax Description
exporter-name
Command Default None
Command Modes netflow-lite exporter submode
Command History Release
15.0(2)SG
Usage Guidelines You can enter this command under the physical port interface mode, port channel interface, or config
VLAN mode.
Examples The following example shows how to configure a monitor on a port interface Gigabit 1/3:
Switch# config terminal
Switch(config)# int GigabitEthernet1/3
Switch(config-if)# netflow-lite monitor 1
Switch(config-netflow-lite-monitor)# sampler sampler1
Switch(config-netflow-lite-monitor)# average-packet-size 128
Switch(config-netflow-lite-monitor)# exporter exporter1
Switch(config-netflow-lite-monitor)# exit
Switch(config-if)# exit
Switch(config)# exit
Switch# show netflow-lite monitor 1 interface gi1/3
Interface GigabitEthernet1/3:
Netflow-lite
Statistics:
exporter exporter-name
no exporter exporter-name
Specifies an exporter.
Modification
This command was introduced on the Catalyst 4948E and Catalyst 4948E-F
Ethernet switches.
Monitor-1:
Active: TRUE
Sampler: sampler1
Exporter: exporter1
Average Packet Size: 0
Packets exported: 0
Packets observed: 0
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
exporter (netflow-lite monitor submode)
2-263