Cisco Catalyst 4500 Series Configuration Manual page 255
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
domain
To configure the fabric domain and enter fabric-auto-domain configuration mode, use the domain
command. The no version of this command deletes the fabric domain.
Syntax Description
default
name name
Command Default
None.
Command Modes
Fabric-auto configuration
Command History
Release
3.9.01E
Usage Guidelines
We recommend that you use the default domain, unless your network requires you to create a new
domain. This command allows you to enter fabric-auto domain configuration mode where you can
configure edge devices in the fabric domain.
Examples
Device(config-fabric-auto)#domain default
Device(config-fabric-auto)#domain name exampledomain
domain {default | name name
no domain
Modification
This command was introduced on the Catalyst 4500-E series switch using a
Supervisor Engines 8-E and 8L-E.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Configures the default fabric domain and enters fabric-auto domain
configuration mode.
Configures a new fabric domain and enters fabric-auto domain
configuration mode.
domain
2-217
Advertisement
Table of Contents
