Show Monitor - Cisco Catalyst 4500 Series Configuration Manual

Chapter 2

show monitor

To display information about the SPAN session, use the show monitor command.
Syntax Description
session
range
session-range
local
remote
all
session-number
detail
Command Default The detail keyword only displays lines with a nondefault configuration.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(13)EW
12.1(19)EW
12.1(20)EW
12.2(20)EW
Examples The following example shows how to display whether ACLs are applied to a given SPAN session on a
Catalyst 4500 series switch:
Switch# show monitor
Session 1
---------
Type
Source Ports
Destination Ports : Fa6/2
Filter VLANs
IP Access-group
show monitor [session] [range session-range | local | remote | all | session-number] [detail]
(Optional) Displays the SPAN information for a session.
(Optional) Displays information for a range of sessions.
(Optional) Specifies a range of sessions.
(Optional) Displays all local SPAN sessions.
(Optional) Displays the RSPAN source and destination sessions.
(Optional) Displays the SPAN and RSPAN sessions.
(Optional) Session number; valid values are from1 to 6.
(Optional) Displays the detailed SPAN information for a session.
Modification
This command was introduced on the Catalyst 4500 series switch.
Added support for differing directions within a single user session.
Output enhanced to display configuration status of SPAN enhancements.
Added support to display configuration state for remote SPAN and learning.
Added support to display ACLs that are applied to SPAN sessions.
: Local Session
:
Both : Fa6/1
Encapsulation : Native
Ingress : Disabled
Learning : Disabled
: 1
: 10
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
show monitor
2-893