Ip Igmp Snooping Vlan Static - Cisco Catalyst 4500 Series Configuration Manual

ip igmp snooping vlan static

ip igmp snooping vlan static
To configure a Layer 2 interface as a member of a group, use the ip igmp snooping vlan static
command. To remove the configuration, use the no form of this command.
Syntax Description vlan_num
mac-address
interface
fastethernet slot/port
gigabitethernet slot/port
tengigabitethernet slot/port
port-channel number
Command Default This command has no default settings.
Command Modes
Global configuration mode
Command History Release
12.1(8a)EW
12.2(25)EW
Examples The following example shows how to configure a host statically on an interface:
Switch(config)# ip igmp snooping vlan 4 static 0100.5e02.0203 interface fastethernet 5/11
Configuring port FastEthernet5/11 on group 0100.5e02.0203 vlan 4
Switch(config)#
Related Commands Command
ip igmp snooping
ip igmp snooping vlan immediate-leave
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-348
ip igmp snooping vlan vlan_num static mac-address {interface {fastethernet slot/port} |
{gigabitethernet slot/port} | {tengigabitethernet slot/port} | {port-channel number}}
no ip igmp snooping vlan vlan_num static mac-address {interface {fastethernet slot/port} |
{gigabitethernet slot/port} | {tengigabitethernet mod/interface-number} | {port-channel
number}}
Modification
This command was introduced on the Catalyst 4500 series switch.
Support for the 10-Gigabit Ethernet interface was introduced on the Catalyst 4500
series switch.
Number of the VLAN.
Group MAC address.
Specifies the next-hop interface to multicast switch.
Specifies the Fast Ethernet interface; number of the slot and port.
Specifies the Gigabit Ethernet interface; number of the slot and port.
Specifies the 10-Gigabit Ethernet interface; number of the slot and
port.
Port-channel number; valid values are from 1 through 64.
Description
Enable IGMP snooping.
Enable IGMP immediate-leave processing.
Chapter 2