Cisco Catalyst 4500 Series Configuration Manual page 602

port-channel standalone-disable
port-channel standalone-disable
To disable the EtherChannel standalone option in a port channel, use the port-channel
standalone-disable command in interface configuration mode. To enable this option, use the no form
of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
The standalone option is disabled.
Command Modes Interface configuration mode
Command History Release
15.0(2)SG1
Usage Guidelines
This command can only be used when the port channel protocol type is Link Aggregation Control
Protocol (LACP). It allows you to change the current behavior when a physical port cannot bundle with
an LACP EtherChannel.
Examples
The following example shows how to enable the EtherChannel standalone option in a port channel:
Switch(config-if)# no port-channel standalone-disable
Related Commands Command
show etherchannel
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-562
port-channel standalone-disable
no port-channel standalone-disable
Modification
This command was introduced on the Catalyst 4500 series switch.
Description
Displays EtherChannel information for a channel.
Chapter 2