Show Flowcontrol - Cisco Catalyst 4500 Series Configuration Manual

show flowcontrol

show flowcontrol
To display the per-interface status and statistics related to flow control, use the show flowcontrol
command.
Syntax Description module slot
interface interface
Command Default This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.2(25)EW
Usage Guidelines Table 2-26 describes the fields in the show flowcontrol command output.
Table 2-26
Field
Port
Send-Flowcontrol-Admin
Send-Flowcontrol-Oper
Receive-Flowcontrol-Admin
Receive-Flowcontrol-Oper
RxPause
TxPause
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-728
show flowcontrol [module slot | interface interface]
(Optional) Limits the display to interfaces on a specific module.
(Optional) Displays the status on a specific interface.
Modification
This command was introduced on the Catalyst 4500 series switch.
Support for the 10-Gigabit Ethernet interface was introduced on the Catalyst 4500
series switch.
show flowcontrol Command Output
Description
Module and port number.
Flow-control administration. Possible settings: on indicates the local
port sends flow control to the far end; off indicates the local port does
not send flow control to the far end; desired indicates the local end
sends flow control to the far end if the far end supports it.
Flow-control operation. Possible setting: disagree indicates the two
ports could not agree on a link protocol.
Flow-control administration. Possible settings: on indicates the local
port requires the far end to send flow control; off indicates the local
port does not allow the far end to send flow control; desired indicates
the local end allows the far end to send flow control.
Flow-control operation. Possible setting: disagree indicates the two
ports could not agree on a link protocol.
Number of pause frames received.
Number of pause frames transmitted.
Chapter 2
OL-30934-01