Command To Display The Entries In The Mac; Show Ip Igmp Snooping Vlan - Cisco Catalyst 4500 Series Configuration Manual

Chapter 2

show ip igmp snooping vlan

To display information on the dynamically learned and manually configured VLAN switch interfaces,
use the show ip igmp snooping vlan command.
Syntax Description vlan_num
Command Default
This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(12c)EW
Usage Guidelines You can also use the
address table for a VLAN that has IGMP snooping enabled.
Examples The following example shows how to display snooping information for a specific VLAN:
Switch# show ip igmp snooping vlan 2
vlan 2
----------
IGMP snooping is globally enabled
IGMP snooping TCN solicit query is globally enabled
IGMP snooping global TCN flood query count is 2
IGMP snooping is enabled on this Vlan
IGMP snooping immediate-leave is disabled on this Vlan
IGMP snooping mrouter learn mode is pim-dvmrp on this Vlan
IGMP snooping is running in IGMP_ONLY mode on this Vlan
Switch#
show ip igmp snooping vlan vlan_num
Number of the VLAN; valid values are from 1 to 1001 and from 1006 to 4094.
Modification
This command was introduced on the Catalyst 4500 series switch.
Support for extended addressing was added.
show mac-address-table multicast
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
show ip igmp snooping vlan

command to display the entries in the MAC

2-789