Cisco Catalyst 4500 Series Configuration Manual page 970

show policy-map interface
show policy-map interface
To display the statistics and configurations of the input and output policies that are attached to an
interface, use the show policy-map interface command.
Syntax Description fastethernet interface-number
gigabitethernet interface-number
port-channel number
vlan vlan_id
input
output
Command Default This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(12c)EW
12.2(25)SG
Examples
The following example shows how to display the statistics and configurations of all input and output
policies attached to an interface:
Switch# show policy-map interface
FastEthernet6/1
service-policy input:ipp5-policy
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-922
show policy-map interface [{fastethernet interface-number} | {gigabitethernet
interface-number} | {port-channel number} | {vlan vlan_id}] [input | output]
Modification
This command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
Displays results for full flow policing.
class-map:ipp5 (match-all)
0 packets
match:ip precedence 5
set:
ip precedence 6
class-map:class-default (match-any)
0 packets
match:any
0 packets
(Optional) Specifies the Fast Ethernet 802.3 interface.
(Optional) Specifies the Gigabit Ethernet 802.3z interface.
(Optional) Specifies the port channel.
(Optional) Specifies the VLAN ID; valid values are from 1
to 4094.
(Optional) Specifies input policies only.
(Optional) Specifies output policies only.
Chapter 2
OL-30934-01