Cisco Catalyst 4500 Series Configuration Manual page 267
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
Examples
The following example shows how to enable IEEE 802.1x authentication and to enable multiple-hosts
mode:
Switch# configure t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet6/1
Switch(config-if)# dot1x port-control auto
Switch(config-if)# dot1x host-mode multi-host
Switch(config-if)# end
Switch#
The following example shows how to enable MDA and to allow both a host and a voice device on the
port:
Switch# configure t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface FastEthernet6/1
Switch(config-if)# switchport access vlan 12
Switch(config-if)# switchport mode access
Switch(config-if)# switchport voice vlan 10
Switch(config-if)# dot1x pae authenticator
Switch(config-if)# dot1x port-control auto
Switch(config-if)# dot1x host-mode multi-domain
Switch(config-if)# no shutdown
Switch(config-if)# end
Switch#
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands
Command
show dot1x
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Displays dot1x information.
dot1x host-mode
2-229
Advertisement
Table of Contents
