Heater/Dryer Temperature Does Not Go Up; Problem In Network (Rip Does Not Recognize The Printer) - Roland VersaCAMM VP-540 Service Notes

6-11 HEATER / DRYER TEMPERATURE DOES NOT GO UP
NO CHECKING POINT
The media is not loaded
1
Inappropriate
2 temperature is set on the
machine
3 Media width is too small
Environmental
4
temperature is low
The voltage of power
5
supply is unstable
Bad contact or cut line on
the cable between the
6
Heater Unit and Main
Board
Fuse on the power board
7
is broken
8 Power Board is broken

6-12 PROBLEM IN NETWORK (RIP DOES NOT RECOGNIZE THE PRINTER)

NO CHECKING POINT
Turn off the main power
1
and restart the printer
2
Refix the cable
3
Network problem
4
Main board is damaged
ACTION
Set up the media. User's Manual
Check the temperature
User's Manual
setting
Use a wider media
Raise the environmental
User's Manual
temperature
Check the voltage
Re-fix / Replace the
cable
Replace the fuse on the
power board
Replace the power board
ACTION
Connect them directly
with a crossover cable.
Replace the main board.
REFERENCE
When the setting of print heater/dryer is off, the Heater does
not operate.
When media is narrow, the air-cooling effect by the vacuum
fan increases and it takes time for the heater temperature to
go up.
In cold environment, it may take a long time or the Heater
may fail to reach the preset temperature. Suggest using the
machine under the environment from 20 to 32 °C.
If the voltage is unstable, the heater cannot function fully.
If the cable between the Heater unit and Main Board is
broken, the Heater temperature does not rise. Check the
connection of the each cable or replace it if it is broken.
The temperature of the Heater does not rise if the Fuse
FS300 or FS301 on the power board is burned out. FS300 is
for the print heater and FS301 for the dryer.
The Heater does not work correctly because the signal to the
Heater is not transferred correctly.
REFERENCE
It can be solved by restarting the printer with the main power.
Try it several times.
It can be solved by refixing the network cable. Try it several
times.
The problem may be in the network when they are connected
through LAN. It can be identified whether the problem is on
the printer or the network, by connecting the PC and the
printer directly with a crossover cable.
Main board may be damaged if the problem is not solved by
the measures above.
6-9
OUTLINE
OUTLINE