Insert a wrench through the holes on the Side Frame and
15
loosen the 2 screws to make a gap of 3mm between the
tip of the screw and Idle Pulley Holder.
The gap between the screws and Idle Pulley
can be seen from both front side and rear side
of the machine.
Press [ENTER] key to restart Aging.
16
Insert a wrench through the holes on the Side Frame and
17
adjust the belt position turning the screw 1 and 2 as follows.
Belt leans to the front side of the machine
-Turn the screw 1 carefully in CW to press it to the
Idle Pulley Holder.
* Make sure to have a gap of 3mm between the screw
2 and Idle Pulley Holder when turning the screw 1.
Belt leans to the rear side of the machine
-Turn the screw 2 carefully in CW to press it to the
Idle Pulley Holder.
* Make sure to have a gap of 3mm between the screw
1 and Idle Pulley Holder when turning the screw 2.
SCREWs
AGING
SCAN
SCREW1
SCREW2
SCREW1
SCREW2
4-60
3mm
IDLE PULLEY HOLDER
[ ]