Roland VersaCAMM VP-540 Service Notes page 125

Remove the 2 screws to remove the Tool Carriage Board
8
Stay from the Tool Carriage Assy.
Loosen the 2 fixingscrews as shown in the figure.
9
And loosen the Adjustment Screw.
Loosen the 4 screws as shown in the figure.
10
Remove the Carriage Belt from the plate, and connect
11
the new belt with the scotch tape.
TOOL CARRIAGE ASSY
< Top View / Left Side of the BELT >
ADJUSTMENT SCREW
TAPE
CARRIAGE BELT
3-62
TOOL CARRIAGE BOARD STAY
SCREW
FIXING SCREW
SCREW
NEW BELT
PLATE