Roland VersaCAMM VP-540 Service Notes page 183

Adjustment is completed if the position error of cut line is
8
within +/-0.1mm. If not, select [SETTING] menu again for
further adjustment.
key : Moves cut position towards front
key : Moves cut position towards rear
key : Moves cut position towards right
key : Moves cut position towards left
ENTER key : Saves new setting
MENU key : Moves out SETTING menu
Perform the test print again for confirmation. Adjustment
9
is completed if the position of cut line is satisfactory. If
not, repeat the adjustment again.
CUTTING MENU
CROP-CUT ADJ.
CROP-CUT ADJ.
SETTING
F:+0.30 +0.30mm
S:-0.40 -0.40mm
-
S:
Broken line is indicating the cut line
Before adjustment
4-42
[ ] [ ]
[ ]
[ ]
Fine Adjustment
-
F:
+
After adjustment