Roland VersaCAMM VP-540 Service Notes page 182

From the test pattern, find the value where the print line
4
matches the cut line.
In this case, the correction value for the scan direction is
"-0.3".
If it is difficult to see the cut line visually, use
a magnifier.
Select [CUTTING MENU]> [CROP-CUT ADJ.]>
5
[SETTING], and enter the correction-values found in the
test pattern for both Feed and Scan.
F: Feed direction S: Scan direction
Left: Current value Right: New value
(Setting range: +/-2.00mm In 0.01mm unit)
key : Value of F, towards +
key : Value of F, towards -
key : Value of S, towards +
key : Value of S, towards -
ENTER key : Saves new setting
MENU key : Moves out SETTING menu
Select [CUTTING MENU]> [CROP-CUT ADJ.]> [TEST
6
PRINT], and press [ENTER] key.
The test print and cut will be performed.
A Crop Mark is printed, and detected by the Crop Mark
7
Sensor, and its contour is cut. Confirm the cut line
position on the print visually.
If it is difficult to see the cut line visually, use
a magnifier.
<TEST PATTERN>
Correction-value scale
+2.0 +1.5 +1.0
-2.0 -1.5 -1.0
CUTTING MENU
CROP-CUT ADJ.
CROP-CUT ADJ.
SETTING
F:+0.30 +0.30mm
S:-0.40 -0.40mm
CUTTING MENU
CROP-CUT ADJ.
CROP-CUT ADJ.
TEST PRINT
Broken line is indicating the cut line
4-41
+2.0 -2.0
+1.5 -1.5
+1.0 -1.0
+0.5 -0.5
+0.0 -0.0
Scan
+0.5 +0.0
Feed
-0.5 -0.0
Cut line
[ ] [ ]
[ ]
[ ]
[ ]
[ ]
-0.5