Roland VersaCAMM VP-540 Service Notes page 220

CONTENTS
CODE
Even though the machine carries out the
regular movement, the output of the Wiper
0109 Sensor does not reach the expected value.
Input value from Linear Encoder is not
changed by the Linear Encoder origin setup.
When Motor stops during printing, expected
movement is not completed on some head.
0110
This error occurs when the machine
0111
performs the Auto Crop Mark Detection
Communication error with Cartridge IC driver
0112
There is a problem with Thermistor for Print
0130 Heater
Print Heater temperature has reached 60°C
0135
and above
There is a problem with Thermistor for dryer
0140
Dryer temperature has reached 80°C and
0145 above
CAUSE
Wiper Motor error
Defect of Wiper Unit
Defect of Wiper Sensor
Cut-line or short-circuit of cable and Flexible
cable
Read error of Linear Encoder.
Read error of Encoder on Scan Motor side.
Belt is not fixed to Head Carriage firmly.
Crop-Cut Adjustment in the Service menu
has not been performed.
Cartridge IC driver is broken.
Cartridge IC driver cable has short circuited
or cut-line.
Thermistor cable has short circuited or cut-
line.
Thermistor has a problem.
Print Heater cable connection has a problem.
Thermostat has a problem.
Thermistor has a problem.
Thermistor cable has short circuited or cut-
line.
Thermistor has a problem.
Dryer cable connection has a problem.
Thermostat has a problem.
Thermistor has a problem.
6-11
ACTION
Wiper Motor Replacement
Wiper Unit Replacement
Wiper Sensor Replacement
Cable and Flexible cable Replacement
Confirm whether Encoder Scale is between the slit of
Encoder Module in a whole width of the machine.
Check cable connection between Linear Encoder Board and
Main Board.
Confirm connection between Belt and Carriage.
Linear Encoder replacement
Scan Motor replacement
Main Board replacement
Carry out Crop-Cut Adjustment in service menu.
Ink cartridge IC sensor replacement
Check cable connection around Thermistor.
Thermistor replacement
Check Print Heater
Check Thermostat
Check Thermistor
Check cable connection around Thermistor
Thermistor replacement
Check Dryer
Check Thermostat
Check Thermistor