Roland VersaCAMM VP-540 Service Notes page 105

Disconnect the ink tubes (Carriage Side) from the Y tube
7
joints, and put the scotch tape at the tip of the ink tube to
prevent the ink from coming out.
It is not necessary to replace the ink tubes of
the other side (Carriage Side) of the joints.
Disconnect the ink tubes (Cartridge Side) from the tube
8
joints, and put the scotch tape at the tip of the ink tube to
prevent the ink from coming out.
It is not necessary to replace the ink tubes of
the other side (Cartridge Side) of the joints.
Pull out the ink tubes, and put the new ink tubes in the
9
Tube Guides.
Each four tubes are connected, and the lengths
of both ends are different.
Be careful with the fixing direction of tubes.
P/No.
1000002670 TUBE,SJ-RDG3*4 4LINK VP-300
1000002681 TUBE,SJ-RDG3*4 4LINK VP-540
Connect the new ink tubes to the tube joints (Cartridge
10
Side), and fix them to the Clamps.
Connect the tubes to the tube joints in the fixed positions
with K on top as shown in the figure.
P/Name
JOINTs
CARTRIDGE Side
< Front View >
CLAMPs
< Left Side >
3-42
JOINTs
Upper
CARRIAGE Side
Lower
JOINTs
K
C
M
Y