Disconnect the ink tubes from the Y tube joints, and put
7
the scotch tape at the tip of the ink tube to prevent the ink
from coming out. And remove them from the Clamps.
Open the clamp and disconnect the 3 flexible cables
8
from the Carriage Board.
Remove the Cable Holders and Holder Cable Sheets from
9
the Tube Guides leaving the flexible cables and Holder
Cable Plates.
Y TUBE
JOINTs
PRINT CARRIAGE BOARD
CLAMP
< Back Side >
HOLDER CABLE SHEET
HOLDER CABLE PLATE
3-74
CLAMPs
FLEXIBLE CABLE
TUBE GUIDEs
CABLE HOLDER
FLEXIBLE CABLE
TUBE GUIDEs