3-6 FEED MOTOR REPLACEMENT
Turn off the sub power, and then turn off the main power.
1
Remove the following covers.
2
Maintenance Cover
Left Side Cover
Left Cover
Ink Cartridge Cover
Disconnect the connector of the sensor cable from the
3
Feed Motor Board.
Remove the Cutter Frame.
4
When removing the Cutter Frame, remove the
Sensor Cable on the back side from the
Clamp.
CUTTER FRAME
LEFT COVER
< Left Side >
CLAMP
CABLE
3-25
MAIN POWER SW
< Rear View >
INK CARTRIDGE COVER
LEFT SIDE COVER
FEED MOTOR BOARD
CONNECTOR
< Rear View / In the Ink Cartridge Cover>
CUTTER FRAME
MAINTENANCE COVER