Calibration For Cutting; Preset Function; Maintenance; Disposing Of Discharged Ink - Roland VersaCAMM VP-540 Service Notes

Calibration for cutting

!! IMPORTANT !!
During Print & Cut, [CALIBRATION] in the [CUTTING MENU] is to be set to [0]. It may cause a misalignment
of printing and cutting. This calibration is to be used only when performing cutting only.

Preset function

All menu items listed below can be saved in Presets. It is useful to have saved settings that are different by
media.
- Temperature setting of Heater/Dryer
- [EDGE DETECTION]
- [SCAN INTERVAL]
- [VACUUM POWER]
- [FULL WIDTH S]
- [FEED FOR DRY]
- [CALIBRATION] (in the [CUTTING MENU])
- Cutting conditions
- [ADJUST BI-DIR]
- [CALIBRATION] (for printing)
- [PRINT-CUT ADJ.]
- [CROP-CUT ADJ.]
- [PREHEATING]

Maintenance

Explain the following items referring to the User's Manual.

Disposing of discharged ink

[CHECK DRAIN BOTTLE] message appears when a certain amount of discharged fluid collects in the
bottle.
!! IMPORTANT !!
- When you dispose of discharged ink, make sure to reset the discharged-fluid count from [MENU] >
[SUB MENU] > [MAINTENANCE] > [DRAIN BOTTLE] and press the [ENTER] key. Otherwise, "CHECK
DRAIN BOTTLE" message appears at the inappropriate timing.
- Never place discarded fluid in the location close to fire.
- To store discharged fluid temporarily, use the included drain bottle or durable sealed container such
as a metal can or polyethylene tank, and cap it tightly.
- Dispose of discharged fluid properly, in accordance with your local laws.
7-9
7