Roland VersaCAMM VP-540 Service Notes page 200

Confirm that the belt is not touching the pulley flanges
11
excessively.
When the belt is in improper position, adjust it again. When
it is proper, leave the belt aging on, and go to the following
[ADJUSTMENT ON THE IDLE PULLEY SIDE].
[ADJUSTMENT ON THE IDLE PULLEY SIDE]
12
Confirm the position of the belt.
The position is proper when the belt is not touching the
flanges excessively. When the position is proper, close
this BELT POSITION ADJUSTMENT. When it is improper,
make adjustment as follows.
Belt partly touching the flange is acceptable.
Press [ENTER] key to cancel Aging.
13
Loosen the 2 Fixing Screws located at the left end of the
14
belt eighth to quarter round.
When the screw is loosen more than
necessary, it gives difficulty in adjusting the
belt. Also, you need to be careful with the sharp
edges around it when turning the screws. It
may cause injury.
<TOP VIEW(R)>
<TOP VIEW(L)>
FLANGE
SCAN
NOW AGING
4-59
FLANGE
[ ]
FIXING SCREW
FIXING SCREW